|
|
|
|
Small dimensions and
light weight
Microprocessor controlled board
Antifreezing protection system
Accurate temperature adjustment on central
heating circuits ± 1 °C
Timer room thermostat connection bracket
Pump feature that does not allow the pump
run without water
Automatic by-pass system
Overheat sensor
Electronic ignition
Ignition control with ionization electrode
Pump anti-blockage system
Easily adjustable circulation pump
Low NOx level
Electronic full modulation
Ergonomic and LED controlling board
Operability with
natural gas and LPG
Lower gas consumption, higher efficiency
- Sensor to prevent
overheating : This is the
safety system that provides stopping the burning
operation of the Hung-wall boiler, in case the
temperature of the circuit water is more than
100°C (and the other system sensors cannot
fulfill their duty). In this way, this system
provides damaging the hung wall
boiler.
- Control of the Fire
with Ion Electrode: In case the burner
is going out, the ion electrode, that is
permanently in contact with flame upon the
burner, is sending this situation to the
electronic card and is turning off the gas. In
this way, is prevented the gas consumption and
gas leakage.
- The Automatic By-Pass
System: Our Wall-Hung Boilers are
provided with a by-pass pipe wich is allowing
the water to pass only into one way between all
way crane and return group. In this way, even if
all the cranes of the wall-hung boiler are
closed, it provides the water circulation of 350
lt/h and prevents damaging of the
boiler.
- Anti-Pump Seizing
System preventing the pump working without
water: This is the safety system
stopping the boiler working and preventing Due
to the pressure sensor that is situated on the
circulation pump of the wall-hung boiler, in
case the water pressure on the circuit is under
0,6 bar.
- Anti-Frost System
against Freezing : During cold weather,
in case the water from the inner circuit of the
boiler decreases under 5°C the burner starts
burning and is heating the water till 36°C. In
this way the system prevents cracking of the
circulation pump, heat exchanger and other
pieces of the boiler due to the freezing
events.
- Anti-Block System
Preventing the Jamming of the Pump :
This is the system providing the
functioning of the pump for 20 seconds, once
every 21 hours, in order to prevent the jamming
of the pump, in case the boiler is not used for
a long period.
- A Special Filter on the
Entrance of the Cold Water : Due to the
filter positioned after the ball valve allowing
the boiler to receive water, it provides the
possibility to clean the water from foreign
substances.
- Safety Valve :
In case the pressure of the water is exceeding
over 3 bar, this valve is providing the
evacuation of the water surplus from the system
by using this valve in order to prevent the
damage of the boiler.
-
The
Gradual Circulation Pump
: This is a system
providing the adjustment of According to the
client/user demand.
- Elektronic Full
Modulation : Due to a special programme
electronical card situaated on the boiler, all
the operations regarding the values are provided
by an delectronic card.
- Electronic
Ignition: Using only one button it
provides electronic ignition and the functioning
of the boiler.
- The Values of hot water
indicated by led index : Situated on
the front panell of the boiler this is the
system informing the user about the water
temperature.
- A Sensible Setting of
the Water of Central System and of Heating
: Due to the sensors, different for hot
water and heating system of the boiler a
temperature setting of ±1°C can be done
providing also savings of gas and a better
confort.
- Isolation Protection
: Our wall hang boiler are produced
from inox sheet iron using the best tehnology of
moulding. The burning room is very well
isolated, having also an extra second isolation.
Due to this second isolation it achieves a 5 %
savings and isolation against noise, providing a
better functioning and more confort. This
isolation system is realised from one piece
only, being a high quality system in
Europe.
|
| star front
panel |
 |
A. Domestic water
temperature adjustment button
B. Off-Reset
button and summer/winter adjustment
C.
Central heating circuit temperature adjustment
button
D. Manometer (Pressure gauge)
E.
Power gauge
F. Flame indicator
G. Displays
the temperature of heating system or break downs
as is flashes | |
|
 |
| Room Thermostat
(OPTIONAL) |
• Stabilizes the room
temperature
• Ensures energy saving till
20%
| |
